How to maintain the chain of trackless flat car

The trackless flat car equipment is a kind of wheeled handling equipment. It has a handle, remote control, table top, and fixed wheels to operate together. It can walk and turn at will without restrictions. It can run in places where the route is not fixed. The vehicle is equipped with warning equipment and detection devices. When encountering pedestrians or obstacles, it will alarm immediately and stop automatically. The chain adjustment should be tight and flexible. The chain spring should be installed on the outside. The open end should be opposite to the direction of movement, Do not rub with the chain guard and crank. If the chain is too tight, adjust the chain adjusting nut counterclockwise according to the above method to make the rear wheel move forward slightly.

How to maintain the chain of trackless flat car

1. We all know that the chain will become loose after the trackless flat car is used for a long time, so we often check and adjust the tightness of the chain, and check whether the locking plate at the chain interface is disengaged.

2. Wipe it frequently and add a small amount of engine oil regularly. This maintenance method is as simple as a bicycle.

3. If the chain is too tight, adjust the chain adjusting nut counterclockwise according to the above method and move the rear wheel forward slightly.

4. The chain should be adjusted with appropriate tightness and flexible operation. The chain spring should be installed outside. The open end should be opposite to the direction of movement and should not collide with the chain guard and crank.

Maintenance method of trackless electric flat car:

1. Remove the sprocket cover Check the sprocket for deformation or wear. The adjustment skills and maintenance of the chain of the trackless electric flat car should not be neglected, which determines the life of the trackless electric flat car

2. If it is caused by the chain wheel, please repair and replace the chain wheel. When replacing the gear, select some matching products, and select the original manufacturer to avoid secondary damage.

3. Check whether the positions of flywheel and rear wheel are offset, and adjust them if any.

4. The flywheel is worn and replaced, which is very common, especially in the vehicle with motor. As long as it is replaced in time, there is no problem.

5. Replace the chain if it is deformed or worn. Note that the opening direction of the chain interface is opposite to the movement direction of the chain.